====== Why Do I Get a Message After Installation Saying that the Workstation Is Not Configured To Run On The EME Network? ======
\\
**Question Submitted by Yarmouth Fire - July 07, 2008**
\\
\\
\\
After installation of the EMCenter and when running the system for the first time you may see the message ...

{{:faq:faq_yfd_2009_july_08_c.jpg|}}
\\
\\
This occurs because during the installation of the EMCenter you were prompted to enter the EMCenter client name.

{{:faq:faq_yfd_2009_july_08_a.jpg|}}
\\
\\
The information is then stored in the registry under HKEY_LOCAL_MACHINE\\SOFTWARE\\STI\\SETTINGS CLIENT_NAME.
\\
\\
In order for the EMCenter client to them be able to run and be allowed to access the system a corresponding entry with the same name must be configured in the "Workstations" section of the admin configuration window. 
\\
\\
{{:faq:faq_yfd_2009_july_08_b.jpg|}}